Table of Contents
Advertisement
① Switch off the power by pressing off button located
behind the printer
Please make sure to check the following items before turning the power on.
1) Any cable twist, bending issues in connection to power source.
2) loaded state of filament spool/direction of rotation
3) Teflon tube is not interfered.
4) Check the condition of the Extruder cable as during unpacking, any cable damages related to connection of
the extruder.
5) Check the state of the extruder module installation
During transportation, there could be loose screws of extruder module.
6) Check whether heated bed is at exact location. It could have moved and be at wrong position due to vibration
during transportation.
7) Any damaged parts.
8) Any residue of package
③ Turn on the power by pressing switch located
behind the printer.
* In case power and USB cable are separated, do not pull the cable, just pull the connector.
* USB cable is connected to PC to print directly from PC source or to get firmware updates.
USB cable does not need to be connected at all times where PC is not required.
* Once powered on, main components regarding heating components will be checked up
automatically.
If "Cubicon Ready" becomes "Check SelfTestResult", it is an indication that there could be
an error in main component inside printer.
operation of the printer until you make sure to check the components indicated as fail in
Function Menu {Configuration>SeftTest Result}. In case that self-remedy seem difficult,
please contact nearest After Service Center.
Do not turn off the printer with temperature of the Extruder still heated. When cooling fan
does not move because power is off, it could damage the electronic components inside the
printer, eventually damaging the printer.
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.
Unpacking and Installation (4/4)
Turn on printer power
② Insert power cable to power source located on the
back of the printer, and neatly arrange the cables
and then hook up the power cable from the power
adaptor to the power source.
④ Check the LCD screen.
Power on
Initial state
*number changes according to ambient temperature
When this happens, please do not start the
11
Advertisement
Table of Contents
