Entering The Communication Settings - CareFusion Pyxis MedStation 4000 User Manual

—
Chapter 3 Setting Up the System
24
8. Complete the steps outlined in the next section, Entering the communication
settings.

Entering the communication settings

This section describes how to complete the Comm tab.
1. Click the tab.
Comm
2. In the box, type
Method
This indicates the method by which the device communicates with the
console.
3. In the token section, enter the applicable information:
• Token 1—Specify the IP address.
• Token 2—Specify a network number.
• Token 3—Reserved for user-defined (UA) methods.
4. If you want the console to poll each station for transactions or activities that
need to be reported, select the
following should occur:
• Poll Data—If the console sends or receives data for this station in a
previous session, specify how often it polls this station.
• Poll Fail—If polling fails, specify how soon the console retries polling.
• Poll No Data—If the console sends or receives no data to this station in
the previous session, specify how soon the console polls this station.
If this station has no transactions, the console passes information to the station
and continues querying the next station. This cycle of polling is continuous
until you turn it off. Generally, you would not turn off polling unless so
advised by a CareFusion representative.
.
XT
check box and indicate when the
Polling
Pyxis MedStation 4000 System Console User Guide