Sony HVR-S270J Service Manual page 318

3-11. PENDULUM RETAINER AND PENDULUM ARM ASSEMBLY
Disassembly: Remove them in order of 1,2,3
(To attach them, perform the disassembly steps in reverse order.)
1
Screw
3
Pendulum arm
assembly
Shaft
Shaft
Shaft
B
Positioning boss
Adjust the space according to the following procedure when you install Pendulum Retainer.
1 Fix Pendulum Retainer with the Screw.
2 Move the Reel to the position of Mini cassette.
Press the Claw of Reel Select Slider in the direction of arrow
until it stops.
3 Loose the Screw of Pendulum Retainer and adjust to make 0.5
mm gap between Pendulum Retainer and S Reel, then tighten
the Screw.
4 Return the Reel to the position of L cassette.
Press the Claw of Reel Select Slider in the direction of arrow
until it stops.
HVR-S270J/S270U/S270N/S270E/S270P/S270C
Tightening torque of pendulum retainer
0.3432 ± 0.0196 N • m (3.5 ± 0.2 kg • cm)
2
Pendulum retainer
(Remove in the direction
of the arrow.)
A
Shaft
B
Notes during assembly
When assembling or disassembling the pendulum arm assembly,
be careful of the following.
[Rear side of pendulum retainer]
Hole
E
Shaft
Insert tip of the pendulum
D
arm into hole of the pendulum
E
retainer and insert the pendulum
into shaft .
C
Attach the pendulum retainer to shaft B. Be careful of the positions
of the pendulum stopper at the rear of the chassis and shaft A of
the pendulum arm.
Shafts
B
Can be removed.
Shafts
B
Cannot be removed.
Reel (Large) Block Assy
(S Reel)
Screw
Reel (Large) Block Assy
(S Reel)
Screw
6-84
D
F
Shaft
C
Slide the pendulum arm in
the direction of arrow
attach it to the chassis.
Pendulum stopper
Shaft of the pendulum
A
must be in this position.
Reel (Large) Block Assy
(T Reel)
Claw of Reel
Select Slider
Pendulum Retainer
Reel (Large) Block Assy
(S Reel)
0.5mm
Pendulum Retainer
Reel (Large) Block Assy
(T Reel)
Claw of Reel
Select Slider
Pendulum Retainer
C
and
F