1. Read "Safety" on page v and the "Installation guidelines" on page 19.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. Remove the hard disk drive if one is installed. See "Removing a SAS hard disk
6. Remove the four screws that secure the drive tray to the system board and
Installing the expansion bracket
You can install the expansion bracket.
Figure 13. Installing the expansion bracket
To install the expansion bracket, complete the following steps:
1. Place the expansion bracket in position on the system board.
2. Secure the bracket to the system board with two screws from the option kit or
32
JS12 Type 7998: Installation and User's Guide
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 21.
side up.
cover" on page 22.
drive" on page 24.
remove the drive tray.
Save the screws that secure the tray to the system board. Store the screws in a
safe place.
from the removed drive tray.