Table of Contents
Advertisement
6. Install the expansion bracket. See "Installing the expansion bracket" on page 32.
7. Touch the static-protective package that contains the part to any unpainted metal
surface on the BladeCenter unit or any unpainted metal surface on any other
grounded rack component; then, remove the part from its package.
8. Orient the expansion card and slide the notch in the narrow end of the card
into the raised hook on the expansion bracket; then, gently pivot the wide end
of the card into the expansion card connectors.
If you have other options to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 34.
Removing the hard disk drive tray
Each hard disk drive has a tray that you can remove when removing the hard disk
drive.
Figure 12. Removing a hard disk drive tray
Perform the following procedure to remove a hard disk drive tray.
Chapter 3. Installing and removing options
31
Advertisement
Table of Contents
