Table of Contents
Advertisement
Blade-cover
release
Figure 15. Installing the cover
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade server.
Perform the following procedure to replace and close the blade server cover.
1. Read "Safety" on page v and the "Installation guidelines" on page 19.
2. Lower the cover so that the slots at the rear slide down onto the pins at the
rear of the blade server. Before you close the cover, verify that all components
are installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 36.
Cover
pins
Blade-cover
release
Chapter 3. Installing and removing options
35
Advertisement
Table of Contents
