Installation - ESP aperta EZTAG3 User Manual

Installation

Release hex screw from (Side View)
the bottom of the keypad Push the keypad up to release from mount plate
Thread system cable through the cable entry hole then make
the system connections (as per the wiring diagram), mount the
bracket to the surface and slide the keypad to the mountplate,
re-fit the hex screw to secure into position.
Note: if using more than one keypad, ensure that the keypads are mounted a minimum 185cm apart
4
EZTAG3 Manual_Layout 1.indd 4 18/11/2016 15:28:07