Operation
NOTE - Indoor units connected to a local con-
troller may also be controlled by a centralized
controller. Indoor units respond to the last
command sent. It is recommended that in-
door units be controlled from a single source
of control, either local controller or central-
ized controller but not both, to avoid confl icts
in commands.
After powering on the controller, wait 30 sec-
onds for initialization The indoor unit cannot
be controlled by the controller until initializa-
tion is complete.
Start/Stop Operation
Press the power button.
•
Controller ON: LED display lit.
•
Controller OFF: LED display not lit.
Set Operation Mode
Press the Mode button to scroll through the
mode selections.
•
Cool – System operates in cooling mode.
•
Heat – System operates in heating mode.
•
Auto -- System operates in auto mode.
•
Dry -- System operates in dehumidifi ca-
tion mode. NOTE - fan speed cannot be
adjusted during dry mode.
•
Fan – Fan only, no heating or cooling.
To set (or change) the room temperature
setting (setpoint)
Press the up-arrow & down-arrow buttons to
adjust the setpoint.
When in Auto mode, separate heating and
cooling setpoints can be set. Press the Mode
button to switch between heating and cooling
setpoints.
8