Fluke 6270A Operator's Manual page 36

6270A
Operators Manual
Item
IEEE-488 Connector
RS-232 Connector
AC PWR INPUT
Connector
Master ON/OFF Switch
F1 Fuse Holder
Chassis Ground
Pem Nut
Removable
Manifold/Pressure
Connection
30
Table 8. Rear-Panel Features (cont.)

IEEE-488.2 remote operation interface. Refer to the Remote Programmers
Manual for more information on remote operation.

RS-232 remote operation interface. Refer to the Remote Programmers
Manual for more information on remote operation.

A grounded male three-prong connector that accepts the mains power cord.
Supplies and disconnects mains power to the unit. This switch must be in

the ON (I) position before the Standby button on the front panel will
function.

Line power fuse. See Fuse Replacement for fuse rating information and the
fuse replacement procedure.
A Pem nut that is internally grounded to the chassis. If the Product is the

location of the ground reference point in a system, this binding post can be
used for connecting other instruments to earth ground. (The chassis is
normally connected to earth ground through the three-conductor line cord
instead of through the earth ground binding post.)

All of the pressure connections are made on the rear panel through a
removable manifold. The manifold comes in three localized versions: NPT,
BSP, and SAE. See Rear-Panel Manifold Pressure Connections for more
information. See Specifications for pressure limitations for each port.
Description