Cleaning The Overflow Container; Wireless Temperature Sensor - Siemens EX875LX34E Instruction Manual

Inserting the metal grease filters
Insert the container.
1.
Insert the metal grease filter.
2.
Ensure that the metal grease filter has been
Note:
inserted correctly. Otherwise, the ventilation system
does not work.
Put the filter cover on.
3.
Resetting the saturation displays
Once you have cleaned or replaced the relevant filters,
reset the saturation indicator so that the
indicators go out.
"‚‚
After the appliance has been switched off,
lights up.
Touch the symbol.
:
1.
A signal tone will sound. The metal grease filter
saturation indicator has now been reset.
If lights up, touch the
"‚‚
2.
A signal tone will sound. The activated charcoal filter
saturation indicator has now been reset.

Cleaning the overflow container

Notes
Make sure that the supply to the overflow container
■
is not blocked. Remove any objects that have
entered the appliance once it has cooled down. To
do this, take the filter cover off and take the metal
grease filter and the container out.
Any liquid entering the appliance from above will be
■
collected in the overflow container. Unscrew the
overflow container and empty it. Take the housing
cover off if necessary.
Unscrew the overflow container with both hands.
1.
Notes
– Hold the overflow container level to prevent liquid
from leaking out.
– Take the housing cover off if necessary.
Empty the overflow container and rinse it out.
2.
Clean the overflow container before screwing it back
3.
into place.
Refit the housing cover.
4.
and
"‚ ‹
or
"‚‹ "‚‚
symbol again.
:

Wireless temperature sensor

Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan
after cooking. Store it in a clean, safe place (such as in
its packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Cookware with the silicone patch must not be left
Note:
to soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
Remove dirt and oil splatters regularly.
■
Use a soft cloth or cotton buds and window cleaner
■
for cleaning.
Notes
Do not use abrasive cleaning agents such as
■
scouring pads, scrubbing brushes or cream
cleaners.
Do not touch the sensor window with your fingers.
■
This may make it dirty or scratch it.
Cleaning
en
45