Siemens EX875LX34E Instruction Manual page 48

Trouble shooting
en
"‰ƒ‹‡
The temperature sensor indi-
cator is not lighting up
The indicator on the tempera-
ture sensor flashes twice.
The indicator on the tempera-
ture sensor flashes three
times.
"Š‹‹‹
"Š‹‚‹
—...‹‹
š"
Do not place hot pans on the control panel.
--------
Notes
If appears in the display, the sensor for the
"
■
relevant hotplate must be pressed and held in order
to read the fault code.
If the fault code is not listed in the table, disconnect
■
the hob from the power supply, wait 30 seconds and
connect it again. If the display appears again,
contact technical after-sales and tell them the
precise fault code.
48
The temperature sensor is broken/faulty.
The temperature sensor is not responding and
the indicator is not lighting up.
The battery in the temperature sensor has almost
run out. You may be interrupted the next time you
cook by the battery running out.
The temperature sensor is disconnected.
The operating voltage is incorrect/outside of the
normal operating range.
The hob is not connected properly
Demo mode is activated
Contact the technical after-sales service.
Replace the 3 V CR2032 battery. See the section entitled
~ "Changing the battery"
If this does not solve the problem, press and hold the temperature
sensor button for 8 minutes, and then reconnect the temperature
sensor to the hob.
If the problem persists, contact the technical after-sales service.
Replace the 3 V CR2032 battery. See the section entitled
~ "Changing the battery"
Press and hold the symbol on the temperature sensor for 8 sec-
onds and then reconnect the temperature sensor to the hob.
Contact your electricity supplier.
Disconnect the hob from the power supply. Check that it has been
connected as shown in the circuit diagram.
Disconnect the hob from the power supply. Wait for 30 seconds
before reconnecting it. Touch any touch control in the next
3 minutes. This will deactivate demo mode.