Step 1: Activating The System - SolarEdge storedge Installation Manual

Step 1: Activating the System

1. Verify that the inverter ON/OFF switch is OFF.
2. Move the StorEdge Connection Unit ON/OFF switch to the OFF position.
3. Remove the inverter cover: Open the inverter cover's six Allen screws and carefully pull the cover
horizontally before lowering it.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter cover is
removed.
RISQUE D'ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le couvercle de
l'onduleur est retiré.
4.
Activate the inverter:
a. Verify that the card S/N matches the inverter S/N.
b. Insert the card into the "CARD" slot on the communication board.
c. Turn ON t he AC switch of the main circuit board.
d. LCD shows: Running Script...è Done!
If LCD shows: Failed:
Turn AC OFF and ON (reset), and repeat the activation process.
l
Use the activation code that appears on the certification inverter label to manually activate the
l
inverter.
If the problem persists, contact SolarEdge Support.
l
NOTE
You can use the activation code that appears on the certification inverter label to
activate the inverter in case of a script error or a missing activation card.
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.2
Figure 27: Activation card
Chapter 6: Commissioning the Installation
45