Avtech room alert 4e User Manual And Reference Manual page 47

Reset Defaults
2. Click
3. Click Yes when prompted with "Are you sure you want to Reset Factory Defaults?"
4. Your Room Alert 4E will automatically reboot and attempt to obtain an IP address via
DHCP.
5. To automatically discover your Room Alert 4E on your network, open AVTECH's
Device ManageR. (If you don't already have it installed, download it from your customer
account at AVTECH.com/Downloads.)
If your Room Alert 4E is not accessible on the network, to reset it to factory defaults:
1. With your Room Alert 4E connected to the network and powered on, press and hold the
reset button for at least 10 seconds until the left LED over the network jack turns off and
then on again.
2. Your Room Alert 4E will automatically reboot and attempt to obtain an IP address via
DHCP.
3. To automatically discover your Room Alert 4E on your network, open AVTECH's
Device ManageR. (If you don't already have it installed, download it from your customer
account at AVTECH.com/Downloads.)
TIP
AVTECH Software, Inc.
in the navigation bar to the left.
IMPORTANT: When you reset to factory defaults, you lose all of
your previously configured settings, including password security.
Room Alert 4E
43