Walking Belt Centering - Energetics POWER RUN 1010HRC Owner's Manual

WALKING BELT CENTERING

The walking belt may occasionally need to be centered. First be certain that the belt is
tensioned properly. Start the treadmill and run it at about 4kph. Place the Allen key through
the hole in the rear end cap and into the socket of the adjustment screw. (See picture below)
1. If belt has moved too far to the left:
Turn the left adjustment screw 1/4 turn clockwise (tight) or turn the right adjustment screw
1/4 turn anticlockwise (loose). Take off the rear end caps and make sure both sides of the
rear roller are parallel.
2. If belt has moved too far to the right:
Turn the left adjustment screw 1/4 turn anticlockwise (loose) or turn the right adjustment
screw 1/4 turn clockwise (tight). Take off the rear end caps and make sure both sides of the
rear roller are parallel.
Continue to run the treadmill around 3-5 minutes to ensure the belt has been
centered. Make sure the belt is not too loose to be slippery and you have not made
an over-adjustment.
THE FLEX DECK INDICATORS ON BOTH SIDES OF THE TREADMILL DECK
CAN SHOW THE SOFTNESS OF THE DECK. THE RED INDICATOR WILL MOVE
UP AND DOWN DURING EXERCISING.
14