Belt Adjustment - Energetics POWER RUN 1060HRC Assembly Manual

Immediately wipe of the sweat;
perspiration can ruin the appearance
and proper function of the home
fitness equipment.
Deck Lubrication
The walking belt has been pre-lubricated at the factory. However, it is recommended that the waking
board be checked periodically for lubrication to ensure optimal treadmill performance.
Every 30 days or 20 hours of operation lift the sides of the walking belt and feel the top surface of the
walking board as far as you can reach. If there are signs of silicone, no further lubrication is required. If
it feels dry to the touch, follow the instructions below. Please use a non-petroleum based silicone.
To apply lubricant to the walking belt:
1. Position the walking belt so that the seam is
located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the
lubricant can.
3. While lifting the side of the walking belt, position
the spray nozzle between the walking belt and
the board approximately 6 cm from the front of
the treadmill. Apply the silicone spray to the
walking board, moving from the front of treadmill
to the rear. Repeat this on the other side of the
belt. Spray approximately 4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before
using the treadmill.
Please keep children and pets away from the silicone oil at all times to prevent any swallowing of the
substance.

Belt adjustment

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running
belt has been adjusted properly at the factory. However transportation, uneven flooring or other
unpredicted reasons could cause the belt to shift off center resulting in the belt rubbing with the plastic
side rail or end caps and possibly causing damage. To adjust the belt back to it's proper position please
follow the directions below:
Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the hex
key provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power
cord back into the surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the belt
start to correct itself, moving back towards the center. Repeat the above procedure until the walking
belt is centered. It may be necessary to set walking belt tension once you have completed this procedure
if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping" instructions.
Daily Monthly
Check that all connecting elements
are tightly fitted and in good
condition.
Vacuum underneath treadmill once
a month.
6