Energetics POWER RUN 1010HRC Owner's Manual page 26

COMPUTER TROUBLE SHOOTING GUIDE
ERROR
PROBLEM
CODE
The console has
not received a
signal from the
motor/speed
sensor within
certain time.
E 1
Inspect if the position and distance are proper.
ERROR
PROBLEM
CODE
1. No readout or
abnormal
message on
display
2. Buttons not
working
3. Beeping sound
E 2
POSSIBLE CAUSES
1. Wiring jack has a poor
connection.
2. There is too great a
distance between the
speed sensor and the
magnet on the front roller
pulley.
3. Sensor is faulty and/or
wiring has been
damaged.
4. Magnet on the front roller
pulley is
loose/fallen/missing.
5. Controller is burnt.
Check if the speed sensor is defective or
misplaced.
POSSIBLE CAUSES
1. Damage to IC chipset or
IC base
2. Static Electricity
Interference (static
electricity may transfer
through hand pulse
receiver and damage the
IC)
26
CORRECTION
1. Re-insert the wiring jack
and ensure that a firm
connection is made.
2. Adjust the speed sensor
so that it sits 3mm (+/-
1mm) from the magnet.
3. Replace the sensor.
4. Replace the magnet.
5. Replace the controller.
CORRECTION
1. Check if any cracks and
tilt can be seen on IC
base or broken
pins/leads on IC
2. a) Ensure the grounding
wire is firmly fixed in
place with the screw
b) Examine if there is
any damage to the small
PCB beneath the hand
pulse receiver plastic
cover
c) Check if LCD/LED
works properly