Belt Adjustment - Energetics PR 5900 HRC Assembly Manual

Belt adjustment

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been
adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons could cause
the belt to shift off center resulting in the belt rubbing with the plastic side rail or end caps and possibly causing dam-
age. To adjust the belt back to it's proper position please follow the directions below:
Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the hex key pro-
vided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the belt start to correct itself, moving back
towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking
belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to
the "Walking belt slipping" instructions.
Walking belt has shifted to the right: First unplug the power cord from the surge protector. Using the hex key pro-
vided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the belt start to correct itself, moving back
towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking
belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to
the "Walking belt slipping" instructions.
Walking belt is slipping: First unplug the power cord from the surge protector. Using the hex key provided, turn
both the left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction.
Plug the power cord back into the surge protector and run the treadmill at 4 km/h (2.5 mph). You should now walk on
the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The
tension should be just tight enough not to slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Right and left tension bolts are located at the rear of the treadmill.
EN
DE
FR
IT
EL
BG
PL
RO
TR
9