Method 3 – Power On The Host Through The Front Panel (Sp Cli) - Sun Oracle SPARC T4-1B Installation Manual

10. Switch communication to the server module host.
When the ILOM prompt appears, type:
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started. To stop, type #.
The server module might take several minutes to complete POST. If a boot device
installed with Oracle Solaris OS is accessible locally, the server module boots.
Otherwise, the server module uses the boot net command to seek a boot device
on the network.
You are now connected to the server module host.
11. The server module hardware installation is now complete.
You can now configure the Oracle Solaris OS to meet your needs. See
"Configuring the Oracle Solaris OS" on page
Related Information
"Plan Communication With the Server Module During Installation" on page 15
■
▼ Method 3 – Power On the Host
Through the Front Panel (SP CLI)
You can access the server module SP directly by connecting a dongle cable to the
UCP on the front of the server module.
Caution – Dongle cables are intended for setup, testing, or service purposes and
should be removed when not in use. These cables have not been evaluated for
electromagnetic compatibility compliance and are not to be used during normal
operation. See
1. Configure the terminal device or terminal emulation software with these
settings:
■
■
■
34 SPARC T4-1B Server Module Installation Guide • May 2012
"Dongle Cables" on page
8N1 (eight data bits, no parity, one stop bit)
9600 baud (the default, but can be set to any standard rate up to 57600)
Disable hardware flow control (CTS/RTS)
37.
17.