Motion Control Unit Cable; General-Purpose Control Cable And Control I/O Connector; Connector-Terminal Blocks And Cables - Omron R88D-GT series User Manual

 Motion Control Unit Cable
There are special cables for 1-axis and 2-axis Motion Control Unit operation. Select the appropriate
cable for the number of axes to be connected.
Motion Control Unit
CS1W-MC221/421(-V1)
 General-purpose Control Cable and Control I/O Connector
These cables and connector are used when connecting to Controllers for which no specific cable is
available, and the cable for the Servo Drive's control I/O connector (CN1) is prepared by the user.
Name
General-purpose
Control Cable
Control I/O Connector
 Connector-Terminal Blocks and Cables
These are for connecting to Controllers for which no specific cable is available, and are used to
convert the Servo Drive's control I/O Connector (CN1) signals to a terminal block.
Connector Terminal
Block
XW2B-50G4
XW2B-50G5
XW2D-50G6
Cable
For 1
R88A-CPG@@@M1
axis
For 2
R88A-CPG@@@M2
axes
Model
A cable for the control I/O connector (CN1)
The @@@ digits in the model number indicate the
R88A-CPG@@@S cable length (either 1 m or 2 m).
Example model number for 1-m cable:
R88A-CPG001S
This is the connector for connecting to the Control
R88A-CNU11C I/O Connector (CN1). (This item is a connector
only.)
Cable
The @@@ digits in the model number indicate the
cable length.
XW2Z-@@@J-B24
There are two cable lengths: 1 m and 2 m. Exam-
ple model number for 2-m cable: XW2Z-200J-B24
4-2 Wiring
Remarks
The @@@ digits in the model number
indicate the cable length.
Motion Control Unit Cables come in
four lengths: 1 m, 2 m, 3 m, and 5 m.
Example model number for 2-m
1-axis cable: R88A-CPG002M1
Remarks
Remarks
4
4-16