Master/Slave Configuration - ADJ Encore Profile 1000 WW User Instructions

Encore Profile 1000 WW
displayed. The current gamma setting will be displayed.
2. Use the UP and DOWN buttons to switch the gamma setting.
Fan Speed:
This will let you set your desired fan speed.
1. Plug the fixture in and press the MODE button until "FAN SPEED"
is displayed, and press ENTER.
2. Use the UP and DOWN buttons to switch between the different
fan speeds.
Refresh Rate:
This feature is predominately used when shooting video. Adjust the
frequency setting to clear up any LED flicker that might be seen on
camera.
1. Plug the fixture in and press the MODE button until "FREQUENC"
is displayed. The current frequency setting will be displayed.
2. Use the UP and DOWN buttons to switch the frequency setting.
PCB Temperature:
This will check the current temperature of unit as well as switch
between fahrenheit and celsius.
1. Plug the fixture in and press the MODE button until "OTHER
MODE" is displayed.
2. Press the SET UP button until "TEM:XXXX" is displayed.
3. Use the UP and DOWN buttons to switch between fahrenheit and
celsius.
Encore Profile 1000 WW
The knobs located on the right side of unit are used to adjust the focus
and the zoom. For a tighter/narrow beam move the first/front knob to
the front of the fixture, and move the second knob to rear. For a wider
beam, move the first/front knob towards the middle of the fixture, and
move the second knob towards the middle as well. Adjust accordingly.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 10
Operating Instructions
Focus and Zoom Adjustments
Encore Profile 1000 WW
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave setup. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "Slave Mode" is
displayed. The unit is now set as the "Slave" unit. Each slave unit
must be set to the same setting.
4. Connect the first "Slave" unit to the "Master", and the "Slave" unit
should now start to follow the "Master".
Encore Profile 1000 WW
The Encore Profile 1000 WW comes with 4 replaceable gobos (see
below). To install a gobo, unscrew and remove the phillips screw
located at the bottom of the gobo holder. Gently lift part of the gobo
holder side up and carefully slide the gobo into place. Reinstall the phil-
lips and screw and tighten. Slide the gobo holder into the slot located
at the top of the unit in front of the framing lever.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 11
Master-Slave Configuration
Gobo Install