ADJ Encore Profile 1000 WW User Instructions page 7

Encore Profile 1000 WW
The ADJ LED RC2 infrared remote (sold seperately) has many dif-
fernet functions to control your Encore Profile 1000 WW. To control
the fixture you must aim the controller at the infrared sensor and be
no more the 30 feet away. To use the ADJ LED RC2 you must first
activate the fixtures infrared sensor, to activate the sensor please see
the instructions on page 9.
BLACkOUT - Pressing this button will blackout the fixture.
SELECT PROG - Pressing this button will activate fade mode. Press
the "+" or "-" buttons to adjust the running speed.
FLASH - This button will activate the strobe effect. You can control
the flash rate by pressing the "+" and "-" buttons. Press the White
button again to exit strobing mode.
SPEED - This button is invalid for this fixture.
DMX MODE - This button will cycle between DMX addressing, DMX
channel mode, and dimmer curve selection. Some fixtures will come
with different DMX channel modes. This button will switch between
the different modes. Please see pages 16-22 for DMX modes, values,
and traits.
SLAVE/SOUND ACTIVE - This designates the fixture as a slave fix-
ture in a master/slave configuration. Sound activity is invalid for this
fixture.
SET ADDRESS - Press this button to set the DMX address. Press
this button first, then press the numbers to set the address. If the ad-
dress is correctly set, the LED will flash and the unit will automatically
go into DMX mode.
Example: Set DMX Address 1 Press "S-0-0-1"
Set DMX Address 245 Press "S-2-4-5"
R G B W - Buttons R G B are invalide for this fixture. Press White but-
ton and the use the "+" or "-" to adjust the output intensity. Press the
FLASH button to activate strobing and use the "+" or "-" to adjust the
flash speed.
"+" and "-" - These buttons adjust the flash rate, speed of the fade
mode, and output intensity.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 12
ADJ LED RC2 Operation Encore Profile 1000 WW
DMX Mode:
Operating through a DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs.
Follow the directions below to set your DMX address, DMX channel
mode, and dimmer curve mode.
1. Before connecting to a DMX controller, your fixture has different
DMX channel modes, please select your desired mode by press-
ing the DMX Mode button, and use the "+" or "-" buttons to
scroll through the DMX channel modes. Set the mode before you
address the fixture. See the bottom of this page for the different
DMX modes.
2. Press this button again to enter dimmer curve selection and use
the "+" or "-" buttons to scroll through the dimmer curve modes.
3. After you have selected your mode, set the DMX address for the
fixture by pressing the "S" button. When the "S" button is pressed
the LED's will flash 2-3 times. Use the number buttons to press in
your desired address. See "SET ADDRESS" on page 12 for
examples.
Note: When seeting the DMX address each time a number is pressed
a LED color will flash, when you have set the DMX address correctly
all LED's will flash 2-3 times.
4. Now you may connect the fixture via the XLR connections to any
standard DMX controller. Please see page 12 to for a detailed
descriptions of the DMX modes, values, and traits.
• If the White LED flashes 1 time you are in 1 Channel Mode.
• If the White LED flashes 2 times you are in 2 Channel Mode.
• If the White LED flashes 3 times you are in 3 Channel Mode.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 WW User Manual Page 13
ADJ LED RC2 Operation