Installing Procedure - Mitsubishi GOT1000 User Manual

8.1.2

Installing procedure

1 If a protective sheet is on the GOT, peel off the protective sheet from the
bottom-right corner of the GOT display section, and clean the GOT
surface.
2 Peel the release paper from the back of the new protective sheet, and
attach its adhesive side to the GOT display section.
When attaching the protective sheet, make sure to fit it on the display
section closely without leaving any clearance between them.
3 Peel off the protective film on the protective sheet.
Remark
Replacement time of protective sheet
Check the status of the protection sheet visually by to the daily inspection.
The visibility becomes worse when there is too much dirt and cracks, causing
malfunction. Proceeds replacement promptly.
WWW.NNC.IR
8.1 Protective Sheet
8.1.2 Installing procedure
1
2
3
4
5
6
7
8
8 - 2