About Models Applicable To The Emc Directive; About The Cable Used - Mitsubishi GOT1000 User Manual

5.1.2

About models applicable to the EMC Directive

The following table lists the modules compliant with the EMC Directive.
: Compliant with EMC Directive
Item
GT1020-LBD
GT1020-LBD2
GT1020-LBL
Please use the GOT whose hardware version is later than that described.
Confirm the hardware version with the products rating plate.
(Products that the EMC Directive applies to are marked with the CE mark logo.)
5.1.3

About the cable used

1 General notes on the use of communication cables
Any device which utilizes a data communication function is susceptible to the wider effects of local EMC
noise. Therefore, when installing any communication cables care should always be taken with the
routing and location of those cables. The GOT units identified on the previous page are compliant with
the EMC requirement when the following communication cables are used.
GOT Unit
GT1020-LBD, GT1020-LBL
GT1020-LBD2
2 General notes on the use of the power cable
The GT1020-LBD and GT1020-LBD2 unit demand that the cable for the power supply is 10m or less.
: Not compliant with EMC Directive
EMC Directive Hardware version
A
A
A
GRAPHIC OPERATION TERMINAL
GT1020-LBD
MODEL
IN 20.4 26.4VDC POWER 1.9W MAX
SERIAL 6Y0001 AB
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
JY204D42501C
80M1 IND. CONT. EQ
US LISTED
GT10-C30R4-8P (For Melsec FX series PLC)
GT10-C30R2-6P (For Melsec Q series PLC)
5.1 Requirements for Conformance to EMC Directive
5.1.2 About models applicable to the EMC Directive
WWW.NNC.IR
AB
Hardware version
Existing Cables
1
2
3
4
5
6
7
8
5 - 2