Mitsubishi GOT1000 User Manual page 66

11 - 4 11.1 Standard I/F Setting
11.1.3 Display contents of standard I/F
Precautions for communication between GOT and connected devices
(1) Installing [Communication driver] and downloading [Communication Settings]
To perform communication with the connected device, the following actions are
necessary.
1) Installing [Communication driver] (Up to 1, OS installation)
The driver for [MELSEC-FX] is factory-installed. Install the communication
driver to connect a controller other than a MELSEC-FX.
2) Assigning channel number and communication driver to communication
interface (Communication Setting)
3) Downloading [Communication Settings] (project data) assigned in step 2)
Perform 1), 2) and 3) with GT Designer2.
To change the communication parameter setting after downloading project data,
change the setting at GT Designer2 again.
For [Communication Settings], refer to the following manual.
GT Designer 2 Version
Section 3.7 Communication Interface Setting (Communication settings).
For installation of [Communication driver] (OS) and download of project data, refer
to the following manual.
GT Designer 2 Version
Chapter 8 TRANSFERRING DATA
(2) When [Communication Settings] has not been downloaded using GT Designer2
When [Communication Settings] has not been downloaded, the GOT
automatically assigns the installed communication driver as the standard I/F-1.
WWW.NNC.IR
Screen Design Manual
Basic Operation/Data Transfer Manual