Draın Hose, Water Inlet Valve, And Clıp Box - Blomberg DW 14110 NBL00 Service Manual

13.16. Draın Hose, Water Inlet Valve, And Clıp Box
The drain hose holder is made up two symmetric parts, which fit together by the help of the snaps,
and should be located approximately 30 cm from the hose end.
For disassembling the water inlet valve, the screw of the water inlet valve located on the
concrete sheet is unscrewed. Water inlet valve is taken out by being rotated in the clockwise
direction. (according to the back of machine)
To render services to these components, the operators should
work on the backside of the machine. The concrete sheet should
be removed.
The hose holder is taken out by turning as it is seen in the picture
87
BUILT- UNDER DISHWASHER
30 cm
2011