Installation - Blomberg DW 14110 NBL00 Service Manual

Under certain conditions hydrogen gas may be produced in a hot water heater system that
has not been used for two weeks or more. Hydrogen gas is explosive. If the hot water
system has not been used for such period, before using the dishwasher turn on all hot
water taps and let the water flow from each for several minutes. This will release any
accumulated hydrogen gas. As gas is flammable, do not smoke or use an open flame
during this time.
Do not store or use flammable liquids or vapors in the area of the dishwasher.
When loading items to be washed, position sharp items so that they are not likely to
damage the door seal and load sharp knives with the handles up to reduce the risk of cut-
type nuries.
Do not wash plastic items unless they are marked "dishwasher safe" or the equivalent. For
plastic items not so marked, check the manufacturer's recommendations.
If a malfunction occurs, switch off the appliance and turn off the water supply to the
dishwasher.
Before cleaning or carrying out maintenance, switch off the appliance, disconnect the power
plug and turn off the water supply.
Repairs and technical modifications must be carried out exclusively by a qualified
technician.
If the dishwasher is not in use for an extended period of time (i.e. vacation home), we
recommend you check that the baskets are empty, leave the inside of the dishwasher
clean, leave the door cracked open to allow air to circulate and turn off both the power and
water supply to the dishwasher.
3.2.

Installation

The dishwasher installation must be performed in accordance with the installation manual.
If you did not receive an installation manual order it by calling 1-800-459-9848 or you may
also download it from our web site at www.blombergappliances.com
Installation, maintenance and repair should be performed by a qualified installer. Work by
unqualified persons could be dangerous and may void the warranty.
Do not operate the appliance if damaged, malfunctioning, partially disassembled or if it has
missing or broken parts.
Before installation or service, disconnect the power supply to the work area by unplugging
the unit, "tripping" the circuit breaker or removing the fuse.
Only connect the dishwasher to the power supply when all installation and plumbing work is
complete.
Do not install or store the dishwasher where it can be exposed to below freezing
temperatures or exposed to weather.
When installing the dishwasher, follow basic precautions, including the
following:
BUILT- UNDER DISHWASHER
6 2011