Installer Checklist; Final Instructions; Self Help Hints - Blomberg DW 14110 NBL00 Service Manual

5.20.

Installer Checklist

Your installer must have completed and checked the following:
• The dishwasher is square and level.
• The dishwasher is fastened securely to the cabinetry.
• The dishwasher door opens and closes freely. The dishwasher door must close without hitting
any cabinetry or counter top.
• The inlet water supply is turned on and checked for leaks.
• The drain hose has been connected and checked for leaks. There must be no kinks or
obstructions in the drain hose.
• The drain hose must be installed with a 28" (710mm) high drain loop for drain hook-ups without
any air removed.
• If the dishwasher drain is hooked up to a garbage disposal, the drain hopper plug must be
removed.
• The spray arms are free and rotate freely.
• The rinse cycle has been run.
• The water level will be below the filter screen after the end of the wash program. It is normal to
find some water in the drain filter area.
• Set the water softener to the correct water hardness for your area. If the dishwasher drain is
connected to a garbage disposal, make sure that the drain/hopper plug has been removed.
5.21.

Final Instructions

1. Press the On/Off button to turn the dishwasher on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a washing program.
4. Start the program with the Start/Pause button.
5. Run the dishwasher through one complete cycle. When the progress indicator light "End" lights
up, the wash cycle is completed. Use the On/Off button to turn the dishwasher off.
If the dishwasher does not operate properly, refer to the self help hints.
5.22.

Self Help Hints:

The power indicator light doesn't come on:
• Check to make sure the breaker to the dishwasher is in the on position.
• Check all the wire connections in the junction box are tight and not loose.
No Water is coming into the dishwasher:
• Check to make sure the hot water shut-off is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or comes out of air gap next to the sink.
• Remove drain hose from disposal making sure plug is removed.
If your dishwasher is not operating properly after following these steps:
Contact your dealer to schedule an authorized service agent to inspect
your new dishwasher for any function related failure.
• The manufacturer warranty does not cover installation or customer education service visits.
Please make a copy of your invoice and keep it with this manual and
register your dishwasher on-line.
BUILT- UNDER DISHWASHER
You will find the model and
serial number information on the
label located on the right-hand
side of the inner door of your
dishwasher, as shown above.
35 2011