FRONT PANEL INTERFACE
4.2.8 Custom LED labeling
4.2.8.1 Enhanced faceplate
4
The following procedure requires these pre-requisites:
•
EnerVista UR Setup software is installed and operational
•
The F60 settings have been saved to a settings file
•
The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded from
http://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc
•
Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1.
Start the EnerVista UR Setup software.
2.
Select the Front Panel Label Designer item from the Online Window or Offline Window area, for example under
Settings > Front Panel Label Designer. If the option does not display, it means that the F60 does not have an
enhanced front panel or that no customization is possible. The Online Window has the advantage of displaying the
live fields as opposed to blank fields.
The window displays.
4-24
Figure 4-26: LED panel 2 (default labels)
CHAPTER 4: INTERFACES
and printed
F60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL