Rs232 Faceplate Port - GE F60 Instruction Manual
Feeder protection system
Hide thumbs
Also See for F60:
- Instruction manual (732 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (426 pages)
Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
WIRING
Figure 3-22: RTD connections
3
3.3.8 RS232 faceplate port
A nine-pin RS232C serial port is located on the faceplate for programming with a computer. All that is required to use this
interface is a computer running the EnerVista UR Setup software provided with the relay. Cabling for the RS232 port is
shown in the following figure for both 9-pin and 25-pin connectors.
The baud rate for this port can be set, with a default of 115200 bps.
F60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
3-25
Advertisement
Table of Contents
