Table of Contents
Advertisement
Setting, activation/deactivation
The following functions can be set or activated/deactivated in Infotainment in
the menu
/ → → Light.
▶
Sensitivity adjustment of the sensor for determining the lighting conditions
for automatic driving light control
▶
Automatic driving light control during rain
WARNING
The automatic driving lamp control (position only operates as a sup-
port and does not release the driver from his responsibility to check the
light and, if necessary, to switch on the light depending on the prevailing
light conditions.
CAUTION
Poorer visibility is evaluated by a sensor mounted below the windscreen in the
holder of the rear-view mirror. Do not cover the sensor - the system can be
affected.
Note
The setting (activate/deactivate) of the automatic driving light control during
rain is stored (depending on the Infotainment type) in the active user account
personalisation
» page
59.
LED headlights
The LED headlights (hereinafter referred to as just system) use the journey da-
ta to automatically ensure the best possible light cone in front of the vehicle.
The system operates automatically in the following modes: urban, extra-urban,
motorway and fog.
The static corning light provides for the illumination of the road in the curve.
The system works as long as the light switch is in position .
WARNING
If there is a system malfunction the headlights are automatically lowered to
the emergency position, which prevents a possible dazzling of oncoming
traffic. This reduces the cone of light in front of the vehicle. Seek help from
a specialist garage.
Light Assist
Fig. 73 Installation location versions of the sensor / system on/off
The system automatically switches the high beam on/off in accordance with
the existing traffic (other vehicles) and environmental conditions (e.g. driving
through a lit village).
The high beam on/off is controlled by a sensor or a camera
The system can be activated/deactivated in Infotainment in the menu
→ → light → Light Assist,
Conditions for the system function
The system is activated.
The light switch is in the position .
The vehicle speed is over 60 km/h or for some countries more than 40
km/h.
The windscreen is clean in the sensor area.
Switch on the system
›
Push the lever into the sprung position
light lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position
. The warning light goes out. The high beam turns off.
B
›
If the high beam is is not switched on automatically, move the lever into the
sprung position
. The warning light goes out. The high beam turns on.
A
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
» Fig.
73.
» Fig.
73. The following indicator
A
Lights and visibility
/
77
Advertisement
Table of Contents
