Table of Contents
Advertisement
›
Restore the original position of the third seat row (applies to the seven-seat
version).
CAUTION
When handling the wheel, do not put this down on the lining parts in the area
■
next to the wheel, otherwise there is a risk of damaging these parts.
Before lowering the seats, unlock the lock tongues of the seat belts (the
■
straps must be completely rolled up behind the lining of the rear body pillar) -
otherwise there is a risk of damage to the locks, lock tongues as well as the
seats.
Removing/stowing wheel in vehicles with sound system
The spare wheel is located in a well under the floor covering in the luggage
compartment and is fixed in place with a fastening screw.
Take out the wheel
›
Fold down the backrests of the third seat row (applies to the seven-seat ver-
sion)
»
,
›
Lift the floor covering and fold upward the variable loading floor and flooring
covering.
›
At the same time, pull the two release loops of the third seat row and lift the
seats (applies to the seven-seat version).
›
Press the latch
on the holder in the direction of the arrow
A
›
Press the latch in the direction of arrow
rection of arrow
.
3
›
Unscrew the lock nut in the direction of arrow
›
Remove the bass loudspeaker.
›
Remove the wheel.
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
296
Do-it-yourself
Fig. 345
Take out the wheel
» Fig.
345.
1
and pull out the holder in the di-
2
.
4
›
Insert the bass loudspeaker.
›
Tighten the locking screw in the opposite direction of arrow
» Fig.
345.
›
Insert the connector in the bass loudspeaker.
›
Secure the latch
in the opposite direction to arrow
A
›
Fold back the floor covering or insert the variable loading floor and fold back
the floor covering.
›
Restore the original position of the third seat row (applies to the seven-seat
version).
CAUTION
Before lowering the seats, unlock the lock tongues of the seat belts (the straps
must be completely rolled up behind the lining of the rear body pillar) - other-
wise there is a risk of damage to the locks, lock tongues as well as the seats.
Full wheel trim
Removing the trim
›
Hang the clamps for removing the full wheel trims at the edge of one of the
ventilation openings in the full wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
Installing the trim
›
Press the wheel trim onto the wheel rim at the designated valve opening.
›
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
The back of the wheel trim supplied by the factory or from the ŠKODA Origi-
nal Accessories shows the position for the anti-theft wheel bolt. When using
the anti-theft wheel bolt, this is to be fitted in this point
WARNING
We recommend that you use hub caps from ŠKODA Original Accessories.
A sufficient air supply may not be able to be guaranteed with other wheel
trims to cool the braking system – Otherwise there is a risk of an accident.
until it stops
4
.
1
»
.
Advertisement
Table of Contents
