Table of Contents
Advertisement
Activation/deactivation
Read and observe
and
Activation
The system is activated by selecting reverse gear or pressing the symbol
button» Fig.
280.
When activating, an alarm sounds and the symbol
The mode for traverse parking is displayed on the screen.
Deactivation
The system is deactivated when you press button , switch off the ignition,
put the selector lever in position P, or when you drive forwards at a speed of
more than 15 km/h (the
symbol in the button goes out).
Function surfaces
Read and observe
and
It is possible to adjust the parking and manoeuvring mode by means of the
function surfaces.
Fig. 280
Button for activation / deactiva-
tion
on page 230 first.
illuminates in the button.
Fig. 281
Function surfaces
on page 230 first.
Function surfaces
» Fig. 281
Turns off the display of the area behind the vehicle
A
Mode - traverse parking
B
Mode - parallel parking
C
Mode - driving up to a trailer / distance monitoring
D
Mode - monitor the area behind the vehicle (wide view)
E
Screen settings - brightness, contrast, colour
F
Parking aid (thumbnail display)
G
Switch thumbnail display on/off
Switch to full screen display
Orientation lines and lane
Read and observe
and
In the modes for transverse and parallel parking guidance, orientation lines for
the assessment of distance and lane lines are displayed on the screen.
Screen display
» Fig. 282
The distance is about 40 cm (safety distance limit).
A
The distance is about 100 cm.
B
The distance is about 200 cm.
C
The lane lines terminate approximately 300 cm behind the vehicle.
D
The distance may vary slightly depending on the load of the vehicle and the
road inclination.
The distance between the side lines corresponds approximately to the vehicle
width including mirrors.
Fig. 282
Orientation and lane lines
on page 230 first.
Assist systems
231
Advertisement
Table of Contents
