Warning - PR 5114 Manual

This device is designed for connection to hazardous electric
voltages. Ignoring this warning can result in severe personal injury
or mechanical damage.
To avoid the risk of electric shock and fire, the safety instructions
GENERAL
of this manual must be observed and the guidelines followed. The
specifications must not be exceeded, and the device must only be
applied as described in the following.
Prior to the commissioning of the device, this manual must be
examined carefully. Only qualified personnel (technicians) should
install this device. If the equipment is used in a manner not
specified by the manufacturer, the protection provided by the
equipment may be impaired.
Until the device is fixed, do not connect hazardous voltages to
the device.
The following operations should only be carried out on a
disconnected device and under ESD safe conditions:
HAZARDOUS
VOLTAGE
Repair of the device and replacement of circuit breakers must
be done by PR electronics A/S only.
SYSTEM 5000 must be mounted on DIN rail according to DIN
46277.
The communication connector of SYSTEM 5000 is connected to
the input terminals on which dangerous voltages can occur, and it
INSTAL-
must only be connected to the programming unit Loop Link by way
LATION
of the enclosed cable.
2
Dismantlement of the device for setting of DIP-switches
and jumpers.
General mounting, connection and disconnection of wires.
Troubleshooting the device.
5114V10 7 -UK

WARNING

WARNING
WARNING