TDT System 3 Installation Manual page 27

System 3 Installation Guide 27
Setting-up the TDT equipment.
Most systems are comprised of an RZ device with a built-in Optibit interface
and/or devices shipped in a ZB1PS zBus device chassis with an interface module
mounted in the back slot. Systems may also connect to a laptop using the LO5
interface (less common). Finally, some systems will use a USB interface (less
common). The steps to install/connect, power on, and test your system will
differ depending on how the system interfaces to your computer or laptop.
From here you can go directly to the section for your interface type and work
through the relevant sections in order.
For systems using an For systems using an For systems using a USB
Optibit interface card LO5 Optibit interface, interface,
(PO5/PO5e), go to:
go to:
go to:
Install and connect to Connect to the LO5 Connect to the USB
the Optibit Interface. Optibit Interface. Interface.
Pg 29 Pg 32 Pg 42