HP MSM765 zl Installation Manual page 13

This procedure assumes that there are Ethernet port modules installed in slot A, and that the controller
is installed in slot C. Sample VLAN IDs and names are used. You will need to adjust the procedure
according to slots chosen and VLAN IDs and names used.
About controller ports
The controller features two ports, Internet and LAN. These ports do not have RJ-45 Ethernet jacks.
Instead, these ports connect through the switch backplane and are mapped to specific RJ-45 jacks
on an Ethernet module by VLAN configuration in the switch. The switch references the Internet and
LAN ports according to the switch slot in which the controller is installed. For example, if the
controller is installed in slot C, the first port (C1) corresponds to the Internet port, and the second
port (C2) corresponds to the LAN port.
Define and assign VLANs
1. At the switch CLI prompt, enter:
menu
2. Press Enter. Select Switch Configuration.
3. From the Switch Configuration menu, select VLAN Menu.
4. Select VLAN Names.
Configure the switch for the controller 13