Removing The Swing Unit Static Charge Eliminator - Canon J1 Service Manual

4
Parts Replacement and Cleaning Procedure > Consumable Parts and Cleaning Points > Removing the Swing Unit Static Charge Eliminator
10) Remove two clips [1] of the return roller axis.
11) Pull out the return roller axis and remove two return rollers [2] together with collar.
12) Separate the return roller and collar.
4
Parts Replacement and Cleaning Procedure > Consumable Parts and Cleaning Points > Removing the Swing Unit Static Charge Eliminator

Removing the Swing Unit Static Charge Eliminator

NOTE:
When replacing the consumable parts, be sure to clear the parts counter.
(COPIER > COUNTER > DRBL-2 > FSWG-STC)
(COPIER > COUNTER > DRBL-2 > DL-STC)
1) Remove the front
2) Remove the rear
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)(Refer to page 4-17)
4) Remove the left upper
5) Remove the grate-shaped upper
6) Remove the tray
7) Remove the tray
8) Remove the grate-shaped lower
9) Remove the
10) Remove the processing
F-4-67
11) Remove the screw [1] securing the static charge eliminator at the center of the swing
unit.
12) Remove two screws [2] securing the ground of the delivery side static charge eliminator.
cover.(Refer to page 4-14)
cover.(Refer to page 4-14)
cover.(Refer to page 4-15)
guide.(Refer to page 4-16)
1.(Refer to page 4-23)
2.(Refer to page 4-24)
guide.(Refer to page 4-16)
stapler.(Refer to page 4-31)
tray.(Refer to page 4-21)
4-33
F-4-68
4-33