Installation Procedure; Preparing The Finisher For Installation - Canon J1 Service Manual

6

Installation Procedure

Preparing the Finisher for Installation

1) In the case of Staple Finisher-J1, remove the 2 screws and detach the latch unit.
x2
2) 1-1) Attach the bundled paper anti-fall brush. (only for the Staple Finisher-J1)
6
Installation > Installation Procedure > Preparing the Finisher for Installation
F-6-15
F-6-16
Installation > Installation Procedure > Preparing the Finisher for Installation
1-2) Mount the latch unit using the 2 screws.
(only for the Staple Finisher-J1)
2) Mount the latch lower cover using the 2 bundled screws (tapping M4 x 12).
x2
3)Mount the ground rail using the 2 bundled screws (RS tightening screw, M4
x2
6-9
F-6-17
x 8).
F-6-18
6-9