Adjusting The Tilt; Check The Tilt - Canon J1 Service Manual

6

Adjusting the Tilt

Check the Tilt

CAUTION:
Depending on the condition of the floor of the site of installation, you may need to
adjust the height or the tilt of the finisher.
A discrepancy in the height or tilt of the finisher can well lead to frequency jams.
Check the height/tilt as follows, and make adjustments as necessary.
6
Installation > Adjusting the Tilt > Check the Tilt
F-6-25
Installation > Adjusting the Tilt > Check the Tilt
1) Check the tilt of front side.
Upper side: Measure the distance [A] of the buffer pass unit upper side and the finisher.
Lower side: Measure the distance [B] of the host machine lower part and the finisher lower
part.
[A]: less than 28.5+/-1mm. [B]: less than 28.5+/-1mm. The difference of [A] and [B] is less
than 1.5mm.
[B]
6-14
[A]
F-6-26
6-14