4
Parts Replacement and Cleaning Procedure > Other Parts > Removing the No.1 Flappers and the No.2 Flappers
Removing the No.1 Flappers and the No.2 Flappers
1) Remove the front
cover.(Refer to page 4-14)
2) Remove the rear
cover.(Refer to page 4-14)
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)(Refer to page 4-17)
4) Remove the inlet feed
unit.(Refer to page 4-29)
5) Remove the claw [1] of the No.1/No.2 flapper bushing, and pull out the No.1/No.2 flapper
shaft [2] toward the rear.
6) After detaching the front shaft of the No.1/No.2 flapper [1] from the front side plate,
remove the No.1/No.2 flapper.
4
Parts Replacement and Cleaning Procedure > Other Parts > Removing the No.1 Flappers and the No.2 Flappers
F-4-83
F-4-84
4-39
4-39