Removing The Processing Tray - Canon J1 Service Manual

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Processing Tray
16) Take off an E ring and remove the gear and a belt.
NOTE:
The parallel pin drops when the gear is removed. Be careful not to loose it.
17) Pull out swing device [5] from the delivery direction.
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Processing Tray

Removing the Processing Tray

1) Remove the front
2) Remove the rear
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)(Refer to page 4-17)
4) Remove the left upper
5) Remove the grate-shaped upper
6) Remove the tray
7) Remove the tray
8) Remove the grate-shaped lower
9) Unfasten four snap fasteners [1] and remove the sensor flag [3] from the stack delivery
roller [2].
CAUTION:
F-4-35
Hold the snap fastener at the base when unfastening because the sensor flag arm can
break easily. When fastening, insert the boss of the sensor flag snap fastener in the
hole on the processing tray side.
F-4-36
cover.(Refer to page 4-14)
cover.(Refer to page 4-14)
cover.(Refer to page 4-15)
guide.(Refer to page 4-16)
1.(Refer to page 4-23)
2.(Refer to page 4-24)
guide.(Refer to page 4-16)
4-21
F-4-37
4-21