Main Adjustment; Adjustment Item - Canon J1 Service Manual

5
Adjustment > Outline > Main adjustment > Adjustment item
Outline

Main adjustment

This machine can perform the following adjustment and function setting.
Service mode or both of DIP Switch can carry out adjustment / setting.
CAUTION:
The setting range / setting unit of the service mode and DIP switch shares it.
Because a set value is memorized in Finisher Controller PCB, regardless of a host machine or the setting from a finisher, finally input numerical value becomes effective.

■ Adjustment item

Item
Adjusting the Stacker Alignment Position (A4)
Adjusting the Front Staple Position 5deg (A4)
Adjusting the Front Staple Position Less Than 45deg
(A4R)
Adjusting the Rear Staple Position 45deg (A4)
Adjusting the Rear Staple Position Less Than 45deg
(A4R)
5
Adjustment > Outline > Main adjustment > Adjustment item
Bit setting of DSW1 in the finisher
controller PCB
(LV.1)
ON
SORTER > ADJUST > STALG1
1 2 3 4 5 6 7 8
(LV.1)
ON
SORTER > ADJUST > STP-F1
1 2 3 4 5 6 7 8
(LV.1)
ON
SORTER > ADJUST > STP-F2
1 2 3 4 5 6 7 8
(LV.1)
ON
SORTER > ADJUST > STP-R1
1 2 3 4 5 6 7 8
(LV.1)
ON
SORTER > ADJUST > STP-R2
1 2 3 4 5 6 7 8
Service mode Range Unit
-10 to 10 0.42 mm
-6 to 6 0.49 mm
-6 to 6 0.49 mm
-6 to 6 0.49 mm
-6 to 6 0.49 mm
Default Reference
0 " Adjusting the Stacker Alignment
Position"(page 5-7).
0 " Adjusting the Staple Position"(page 5-7).
0 " Adjusting the Staple Position"(page 5-7).
0 " Adjusting the Staple Position"(page 5-7).
0 " Adjusting the Staple Position"(page 5-7).
5-2
5-2