Main Units; Removing The Swing Unit - Canon J1 Service Manual

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Swing Unit

Main Units

Removing the Swing Unit

1) Remove the front cover.(Refer to page 4-14)
2) Remove the rear cover.(Refer to page 4-14)
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)(Refer to page 4-17)
4) Remove the left upper cover.(Refer to page 4-15)
5) Remove the grate-shaped upper guide.(Refer to page 4-16)
6) Remove the tray 1.(Refer to page 4-23)
7) Remove the tray 2.(Refer to page 4-24)
8) Remove the grate-shaped lower guide.(Refer to page 4-16)
9) Remove the processing tray.(Refer to page 4-21)
10) Remove screw [1] and pull up the swing pressure guide [2].
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Swing Unit
11) Remove the board spring.
12) Remove two E rings [1] at the joint between the swing unit and the return roller unit and
then slide the two return roller unit collars [2] inside.
F-4-29
4-19
F-4-30
F-4-31
4-19