4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Inlet Feed Unit
Removing the Upper Delivery Guide
1) Remove the front cover.
(Refer to page 4-14)
2) Remove the rear
cover.(Refer to page 4-14)
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)
(Refer to page 4-17)
4) Remove the left upper
cover.(Refer to page 4-15)
5) Remove the grate-shaped upper
guide.(Refer to page 4-16)
6) Remove the tray 1.
(Refer to page 4-23)
7) Remove the tray
2.(Refer to page 4-24)
8) Remove the grate-shaped lower guide.
(Refer to page 4-16)
9) Remove two screws [1] and ground wire [2] and remove the upper delivery guide [3].
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Inlet Feed Unit
1) Remove the front cover.
2) Remove the rear cover.
3) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
4) Disconnect four connectors [1] and remove the harness from clamp [2].
F-4-60
Removing the Inlet Feed Unit
(Refer to page 4-14)
(Refer to page 4-14)
unnecessary.)
(Refer to page 4-17)
4-29
F-4-61
4-29