Banner DX80 Installation & Operation Manual page 14

Configuration: Modbus Slave Number. The DX80 gateway can have a Modbus slave address from 1
to 99. Each member of a Modbus RTU serial network must have a unique slave number.
From within the configuration menu, single click button 1 until the LCD display reads 'MODSLV' and
then single click button 2. The LCD will display the current value of the Modbus Slave number and the
rotary switch values. When the rotary switches are set correctly for the new Modbus Slave number, enter
the new value by a single click of button 2. The LCD will briefly display the new Modbus Slave number
before exiting back to the Modbus Slave top menu.
Double click button 2 to put the device back into Run Mode.
Set Password: The password is defined as a 4-digit number used to protect the configuration and
diagnostic areas of the menu system.
Set Name: A user name can be applied to each device. Up to 16 alphanumeric characters can be
stored.
Banner Engineering Corp • Minneapolis, MN USA
Sensonix Incorporated • Plymouth, MN USA
Preliminary Information
www.bannerengineering.com
14 of 18
• Tel: 763.544.3164
• 763.519.7042
www.sensonix.com