Formatting The Hard Drive - Digimerge VB300 SERIES Instruction Manual

Formatting the Hard Drive

ATTENTION: Initializing (formatting) the HDD erases all data
on the hard disk. This step cannot be undone.
To format the hard disk:
1. Press the button to open the Main Menu.
2. Select and press the
3. Select HDD and press the
4. From the HDD menu, press the
Figure 34.4 Select YES to format the hard disk
5. Select YES and press the
button.] The system formats the hard disk, erasing all recorded video data. System
settings and configurations remain intact. After a few moments the system returns to the
HDD menu.
NOTE: Do not turn off the system while the HDD is formatting.
6. Press the button on the remote control until you see the Save/Exit screen. Select SAVE
ONLY or SAVE AND EXIT to save your settings.
button.
button.
button to open the HDD Initialize screen.
button. [Select NO and press the
Appendix H: Replacing the Hard Drive
button to cancel, or the
117