R&Tte (Eu); Telecommunications Standards; Ipos; Fcc Part 68 - Hughes HN7000S User Manual

Telecommunications
standards
Appendix D • Conformance with standards and directives
78
1037073-0001 Revision A
R&TTE (EU)
This product falls within the scope of the EU Radio Equipment
and Telecommunications Terminal Equipment (R&TTE)
Directive.
This section explains compliance with the IP over Satellite
standard (IPoS) and FCC Part 68.

IPoS

The Hughes HN System is compliant with the IP over Satellite
standard (IPoS) ratified by the Telecommunications Industry
Association (TIA-1008), first published in October 2003 and
issued as Revision A in May 2006.

FCC Part 68

This section applies to the HN7700S remote terminal only.
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance -- This equipment (Two-Way Hughes
System: Model Numbers: HN7700S) complies with Part 68 of the
FCC rules and requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among other
information, the product Part Number (P/N) in the format
XXXXXXX-XXXX and an eight digit Electronic Serial Number
(ESN). If requested, this information must be provided to the
Telephone Company.
The Two-Way Hughes system needs to be installed according to
the instructions. Coaxial cables (Rx and Tx) need to be grounded
at the point of entry. A plug and jack used to connect this
equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant 26 Gauge telephone cord and
modular plug is provided with this product. It is required to be
Figure 56: IPoS symbol