Processor And Fan Option - HP proliant DL380 GEN9 User Manual

Install high-performance fans in all locations.
6.
Install the access panel (on page 28).
7.
Slide the server into the rack.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server
11.

Processor and fan option

The server supports single-processor and dual-processor operations.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To install a processor:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 27).
o
Remove the access panel (on page 27).
4.
Remove the air baffle (on page 32).
5.
Remove the processor blank.
6.
("Powering up the server" on page 26).
Hardware options installation 58