Introduction - HID ENTRYPROX User Manual

EntryProx User Manual, 4045-905, Rev. C.4
1

Introduction

This User Manual provides information and instructions for installing, wiring, and programming the
EntryProx™ unit.
IMPORTANT: READ BEFORE PROGRAMMING THE ENTRYPROX UNIT
• Keep a User List – When programming cards and PIN codes into your EntryProx, record each
User Location, Card Number, PIN Code and the Name of the User. Use the blank form in
Appendix: A: Users Chart for Record Keeping as a photocopy master.
• Change the Master Code – Change the Master Code from the factory default (User Location 1,
PIN Code: 1234) to a new code (1 – 6 digits). Programming commands will not work until the
default Master Code is changed. Keep a record of the new code in a safe place.
• Program the New Master Code into Location 0 – Once this is done, the default Master Code in
User Location 1 can now be reprogrammed for normal access control use.
Note: The Rev C EntryProx no longer reserves User Location 1 for the Master Code.
• If the Master Code is Lost:
End Users: Contact your dealer –A service call is required.
Dealers: Call HID Global Technical Support.
• Consider a Secure Installation - For exterior doors or other high-risk locations, a secure
installation is recommended.
September 2016 Page 5 of 38