HID ENTRYPROX User Manual page 34

Ref Option
10 Change Wiegand &
Miscellaneous parameters
11 Set system time
12 Set system date
13 Set door number
14 Set propped door time (this sets
delay time for both the Aux
Relay and local sounder)
15 Set forced door time (this sets
active time for both the Aux
Relay and local
sounder)
16 Delete memory except user list
and restore system defaults
(also see command 46)
17 Delete all memory and reset
system defaults
18 Program user:
Code ONLY
Note: You can program the four
types of users shown to the
right
19 Program user:
Code AND Card
20 Program user:
Card ONLY
20A Program new master code into
user location 0
21 Program card user manually:
Card Only (26-bit cards ONLY)
Page 34 of 38
EntryProx User Manual, 4045-905, Rev. C.4
Press Details
32 # parameter # Parameter/Value
value # **
0, Wiegand pulse width, default=8, 160µs,
(1=20µs), range= 1- 255
1, Wiegand interpulse spacing, default=32,
640µs, (1=20µs), range=1-255
2, Facility Code/0-225
(default = 1) (26-bit cards only) verify!
3, Process card timer 2 – 240 in ¼ second
increments, defaults to 4 – 1 second††
4, Invalid PIN lockout threshold 1 –50
attempts (defaults to 5)
5, Invalid PIN lockout duration 1 – 255 in 5
second increments (defaults to 60 - 5
minutes)
41 # hhmm # 0 # hhmm = hour/minute,
**
24-hr format
42 # mmddyy # mmddyy = month, day, year;
dow # **
dow = day of week, where 1 = Sunday
43 # nnnn # 0 # nnnn = door number (for downloaded
** reports)
44 # ttt # 0 # ** ttt = propped door time, to nearest 10's
seconds, entered as 10 -990; default = 30
seconds
45 # ttt # 0 # ** ttt = forced door time, to nearest 10's
seconds, entered as 10 - 990; default = 10
seconds
40 # 00000 #
00000 # **
46 # 00000 #
00000 # **
50 # user-type # User Types:
user location #
0 - Toggle/latch strike
code * repeat
1 - Normal Access
code *
2 - Log Download
3 - Lockout
50 # user-type #
user location #
code * repeat
code *
<present card>
50 # user-type #
user location # *
*
<present card>
50 # 1 # 0000 #
master code *
master code *
51 # user-type # The card ID appears on the card (Facility
user location # Code must be entered first; see 32 # 2 #
card ID * card ID command)
*
September 2016