Programming Pin Code Only Use; Programming Card Only Use; Programming Code Or Card - HID ENTRYPROX User Manual

7.3 Programming PIN Code Only Use

To program PIN Code operation with Command 50, use the following program sequence:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 50 # user-type # user location # keypad PIN
* keypad PIN *
3. Press * to exit program mode.

7.4 Programming CARD Only Use

To program Card only use with Command 50, simply omit the keypad PIN values from the
sequence:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 50 # user-type # user location # **
<present card>
3. Press * to exit program mode.

7.5 Programming Code or Card

To program a user for either Code OR Card:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 52 # user-type # user location # keypad PIN
* keypad PIN * <present card>
3. Press * to exit program mode.
Page 26 of 38
EntryProx User Manual, 4045-905, Rev. C.4
September 2016